MON-FRI:8:00 am - 5:00 pm
SAT:8:00 am - 12:00 pm
Land Pride RGA1266
Double tap to zoom
|American made||American made means better quality & parts availability. Most tillers are imported.|
|Tractor hp range 42" & 50"
58" & 66"
|Reverse tilling action (RGR only)||Reverse action ‘sucks’ tiller into ground, does not walk on top of hard ground like
forward rotation tillers can.
|42", 50", 58", 66", 74", & 82"
|A wide range of widths are available to meet specific customer needs.|
|7" Tilling depth||For deep soil penetration.|
|Formed plate steel upper hitch||Plate steel is stronger than flat bar type hitch.|
|Fits Land Pride Quick Hitch||Allows for quick and easy one person hook-up.|
|Park stand||Allows for easy hook-up and storage.|
|Adjustable skid shoes||Control depth with seven adjustments|
|Formed and reinforced
|Keeps dirt in and leaves a level finish. Forming gives deflector additional strength.
Adjustable deflector allows for various finish results.
|Front deflector (RGR only)||Front deflector is flexible to take the beating from rocks or debris.|
|Bolt in rotor||Rotor removes and replaces easier for servicing.|
|17" Rotor swing diameter||For deep tilling and turns the soil over faster.|
|Six “C” shaped, heat-treated
tines per flange
|“C” Shaped tines require less hp to move through the ground.
Six tines per flange make for a better seedbed in less time than four tines.
|Double lip seal on rotor bearing||Double lip seal helps keep the dirt out and the grease in.|
|Fully shielded slip-clutch driveline||Protects gearbox and rotor shaft upon hitting obstructions.
Slip-clutch saves having to replace shear-pins.
enclosed in oil bath
|Gear drive requires less maintenance than roller chain drive.
Oil bath keeps wear to a minimum.
|Stamped gear case cover||Stamped forming gives the chain cover strength.|
|Optional BX driveline||This driveline will fit B and BX Kubota tractors without cutting it to fit.
Not quick hitch adaptable for B & BX Kubota tractors.
|Recommended tractor PTO hp||23 to 60 hp|
|Working depth||7 in.|
|Overall width||71 1/8"|
|3-Point hitch type||Category I, 3-point plate steel A-frame, Fits Land Pride Quick Hitch|
|Driveline||Category 4 with Slip Clutch|
|Optional BX driveline||Category 4 with Slip Clutch, Not recommended with Quick Hitch|
|Number of flanges on rotor||8|
|Number of tines per flange||6|
|Tine construction||Alloy steel heat-treated “C” shaped blades|
|Rotor rotation||Forward rotation|
|Rotor swing diameter||17"|
|Rotor shaft speed||211 rpm at 540 rpm PTO|
|Rotor bearing mount||Machined cast iron with ball bearings|
|Front deflector||None (Not required with RGA forward rotation)|
|Gearbox construction||50 hp input at 540rpm 1.92:1 ratio, Cast iron housing with ASAE 1 3/8" - 6 spline shaft,
tapered roller bearings, bevel gears, drain plug, level plug & fill plug
|Gearbox lubrication||2 Pints of SAE 80-90W EP oil|
|Drive end construction||Spur gears enclosed in an oil bath with oil level plug or sight glass and oil fill/breather plug|
|Gear case lubrication||6 Pints of SAE 80-90W EP oil|
|Spur gears||Case hardened teeth|